Trailer Valet JX Series
What is the recommended drill torque setting?
We recommend keeping the torque setting as low as possible while still lifting the trailer. A heavier load will require a higher torque setting. Regardless of drill setting, the drill must be slowly engaged as opposed to suddenly pulling the drill ...
How do you recommend propping up the trailer for installation?
A few suggestions we have for propping up your trailer are using your existing jack, a stabilizer block, jack stands, or wood blocks. You will need at least 16-18” of height to properly install the JX.
Can the center jack (JXC) be welded rather than bolted?
Yes, at your discretion. But note that welding will void the return warranty.
Do I need to grease the gears before use?
No, the JX will come already lubricated. We recommend greasing the internal acme rod every 90 days via the grease zerk/fitting near the drive shaft. General purpose grease can also be applied periodically directly to the miter gears of the unit by ...
What is the load capacity of the JX?
JX2-C: Static Load Capacity: 2,000 lbs Lift (Manual crank): 1,200 lbs Lift(Using power drill with adapter): 600 lbs JX2-S: Static Load Capacity: 2,000 lbs Lift (Manual crank): 1,200 lbs Lift(Using power drill with adapter): 600 lbs JX5-C: Static Load ...
Does the JX come with a caster wheel?
Each JX comes standard with a foot plate. Caster wheels for the JX 2S, 2C, 5S, and 5C are sold separately. Currently, we do not sell a jack wheel compatible with the JX 7K variant.
Does the JX Center Mount come with bolts for installation?
Three (3) 3/8" diameter, 1" long, grade 5 bolts and lock washers are provided for installation. However, depending on your coupler, alternative bolts may be needed to fit the particular threading of your coupler. Please reference you coupler's manual ...
What type of Mount Bracket comes with the JX2-S and JX5-S?
The JX2-S and JX5-S come with a smaller bracket that can be mounted on a 4” frame and needs 6” of clearance to install. The larger JLBM Bracket can be purchased for the TVJX5-s that can be mounted on a 5” frame and needs at least 8” of clearance to ...
What is the best position for the JX5-S Mount Bracket to be installed?
The connection point should be in the low position (recommended). However, it can be flipped to the high position if needed.
How much does the JX weigh?
JX2-S: 23 lbs JX5-S: 24 lbs JX2-C: 13 lbs JX5-C: 15 lbs JX7-S: 27.5 lbs
Can the JX be submerged in water?
Can the JX be submerged in water? It is recommended to avoid submerging the unit if possible as this may erode lubricants on the internal mechanisms. If the unit is exposed to salt water, it is advised to rinse the unit with fresh water.
Can the JX be stored outdoors?
Yes, the JX has three layers of weather protection and can be stored outdoors with your trailer.
What kind of drill should I use with the JX?
What kind of drill should I use with the JX? Any 18-24V compact non-impact drill can be used with the Trailer Valet Drill Attachment. We recommend higher voltage drills as they can handle heavier loads with ease.