Do I need to grease the gears before use?

Do I need to grease the gears before use?

No, the JX will come already lubricated. We recommend greasing the internal acme rod every 90 days via the grease zerk/fitting near the drive shaft. General purpose grease can also be applied periodically directly to the miter gears of the unit by removing the gearbox cap as needed.


    • Related Articles

    • What kind of drill should I use with the JX?

      What kind of drill should I use with the JX? Any 18-24V compact non-impact drill can be used with the Trailer Valet Drill Attachment. We recommend higher voltage drills as they can handle heavier loads with ease.
    • Can the JX be stored outdoors?

      Yes, the JX has three layers of weather protection and can be stored outdoors with your trailer.
    • Does the JX come with a caster wheel?

      Each JX comes standard with a foot plate. Caster wheels for the JX 2S, 2C, 5S, and 5C are sold separately. Currently, we do not sell a jack wheel compatible with the JX 7K variant.
    • Can the JX be submerged in water?

      Can the JX be submerged in water? It is recommended to avoid submerging the unit if possible as this may erode lubricants on the internal mechanisms. If the unit is exposed to salt water, it is advised to rinse the unit with fresh water.
    • How do you recommend propping up the trailer for installation?

      A few suggestions we have for propping up your trailer are using your existing jack, a stabilizer block, jack stands, or wood blocks. You will need at least 16-18” of height to properly install the JX.